Re: Voltage recommendation for slosyn kml063f07

Hi Chris,

Bob C. has said he got his for $149, from www.electrosales.com, I
think. I sent them mail requesting a quote, and a new catalog.

I'd heard they had a Sac store, but haven't had a change to stop in. I
LEFT the two with damaged leads, even 'tho one had an nice coupler on
it.

Probably a little to big to put on a Sherline mill!

Alan KM6VV


resosys wrote:

>
> --- In CAD_CAM_EDM_DRO@y..., Alan Marconett KM6VV <KM6VV@a...> wrote:
> > Hi Chris,
> >
> > Funny you should mention KML063F07's! I just got four! I don't
> have
> > any "experience" with them yet. Are you in Sunnyvale, by chance?
> Your
> > info matches what I've found. What I was also looking for is the
> LIST
> > price.
>
> I am also looking for the list price. I got them at the Sacramento
> HSC store. The Sunnyvale store only has two left and they have
> damages leads.
>
> >
> > I'm planning on using a 28V, 6A xfmr for mine. This gives 37-40V (I
> > also have input taps to play with. A 6A rating should drive 3 or 4
> > motors fine. I will also put in a 2nd transformer, so that I can
> go up
> > to 75-80V at a later date.
>
> That sounds about right. I don't need the full torque or speed at
> this point. I am planning on searching for some surplus power
> supplies. I just wish RA enterprises hadn't closed up shop.
>
> >
> > A good cheap supply is a 24V 6-8A regulated supply. Just connect
> right
> > at the cap, and get a good 37V out of them! Often you can
> find "bad"
> > supplies, that have a blown regulator, but a perfectly GOOD bridge,
> cap
> > and transformer.
>
> Hmmm, I'll have to check into this. I have access to a stack
> of "blown" power supplies at work.
>
> If you find the list price, please let me know.
>
> Thanks,
>
> Chris