Re: Voltage recommendation for slosyn kml063f07

--- In CAD_CAM_EDM_DRO@y..., Alan Marconett KM6VV <KM6VV@a...> wrote:

> Hi Chris,
>
> Funny you should mention KML063F07's! I just got four! I don't

have

> any "experience" with them yet. Are you in Sunnyvale, by chance?

Your

> info matches what I've found. What I was also looking for is the

LIST

> price.

I am also looking for the list price. I got them at the Sacramento
HSC store. The Sunnyvale store only has two left and they have
damages leads.

>
> I'm planning on using a 28V, 6A xfmr for mine. This gives 37-40V (I
> also have input taps to play with. A 6A rating should drive 3 or 4
> motors fine. I will also put in a 2nd transformer, so that I can

go up

> to 75-80V at a later date.

That sounds about right. I don't need the full torque or speed at
this point. I am planning on searching for some surplus power
supplies. I just wish RA enterprises hadn't closed up shop.

>
> A good cheap supply is a 24V 6-8A regulated supply. Just connect

right

> at the cap, and get a good 37V out of them! Often you can

find "bad"

> supplies, that have a blown regulator, but a perfectly GOOD bridge,

cap

> and transformer.

Hmmm, I'll have to check into this. I have access to a stack
of "blown" power supplies at work.

If you find the list price, please let me know.

Thanks,

Chris