Re: Surface Mounting Components.

A venturi and an air compressor works good. You can use an air nozzle or a
solenoid to activate the vacuum.
Darrell

----- Original Message -----
From: Earl J Morris <ejmorris@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Saturday, December 25, 1999 6:28 PM
Subject: Re: [CAD_CAM_EDM_DRO]Surface Mounting Components.


> From: Earl J Morris <ejmorris@...>
>
>
> Greetings Hans
>
> I have been using various manual solder suckers for over thirty years
> as a field service engineer. As they say, "It is in the technique". They
> work fine, but I have a large quantity of circuit that I am boning for
> parts. Operating the plunger stresses my body parts after a while.
>
> The commercial units go for over $500.00, although the hollow tips are
> reasonably priced. Using a small pump, storage tank, and a solenoid valve
> should be able to replicate the commercial units.
>
> Earl
>
> >
> > Earl,
> > I think I would try to buy a solder sucker, at least the Iron, you will
> > need a good supply of "bit" and homemade ones would be eaten away much
> > to quickly.
>
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>