Re: DYNA 2400 SOFTWARE

I just added the serial cable wiring diagram out of the Dyna 2400
mill book to the DynaComm folder in the files section. It's a
standard cable with CTS and RTS wired together. I also confirmed
today that DynaComm will work on Win98-XP but you must have the .NET
framework installed. It's about a 23MB free download from
Microsoft. I've got a line execute mode partially working, I just
don't seem to be getting any data back from the Dyna saying it's
ready for the next line of code. When this is working it will allow
programs longer than 900 lines to be run by feeding them one at a
time from the computer. I've also notice that MasterCam
automatically starts the line numbers over at 000 when you go over
900.

Jeff