OT thank you was Re: DenverCNC?

Thank you Derek!

Ballendo

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Derek B."
<hightechsystems@c...> wrote:

> Hi Ballendo,
>
> Currently, no pun intended, it uses a 4Amp supply, Xylotex boards
> and a circuit board made by DenverCNC.com.
>
> Derek B.
> WWW.DenverCNC.com
>
>
> > -----Original Message-----
> > From: ballendo
> >
> >
> > Derek,
> >
> > What is the amp rating of the 24volt power supply in the

DenverCNC

> > driver box? Does it use the xylotex drives?
> >
> > Thank you in advance,
> >
> > Ballendo
> >