Re: [CAD_CAM_EDM_DRO] Re: Recommended CAM software? - BobCad

In a message dated 9/21/2004 10:31:24 AM Mountain Daylight Time,
metlmunchr@... writes:
By the way....I wanna know how Fred likes his new title of "ultimate
dongle". That's a truly prestigious title :)
I think it is an HONOR, also add in "Automatic Support Guru"

At least you can count on Fred for an answer, and he will keep at it until
you can understand, and use the software.
Out of hundreds of posts about BobCad on this and other forums, the negatives
run at least 200:1 against BobCad.
The few against Vector, are usually from refusing to understand that it is
not AutoCAD.
Personally my hat is off to Fred and his support.
bill

I know I should not take a position, but sometimes it is necessary to do so.
bill
List Mom


[Non-text portions of this message have been removed]