CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: encoder

Posted by Jon Elson

on 2004-09-25 16:26:34 UTC

R Rogers wrote:

>You probably need encoders. Geckos will only handle encoders with less than .05 milliamp draw.
>

Not quite. 0.05 AMPS = 50 mA; .05 MilliAmps is 50 Microamps (uA). You
will NEVER find an encoder
that works on 50 uA, as it needs an LED to shine through the grating.
50 mA is reasonable, but you
may find some older encoders that draw more.

Jon

Discussion Thread

alex 2003-02-18 08:26:47 UTC encoder motorworksnf 2003-09-02 18:23:57 UTC encoder Antonius J.M. Groothuizen 2003-09-02 18:44:35 UTC Re: encoder GRautoHP@a... 2004-09-24 14:39:05 UTC encoder Leslie Watts 2004-09-24 16:24:18 UTC RE: [CAD_CAM_EDM_DRO] encoder caudlet 2004-09-24 16:43:12 UTC Re: encoder GRautoHP@a... 2004-09-25 10:05:43 UTC Re: [CAD_CAM_EDM_DRO] Re: encoder David Paulson 2004-09-25 10:10:54 UTC Re: [CAD_CAM_EDM_DRO] Re: encoder R Rogers 2004-09-25 14:57:45 UTC Re: [CAD_CAM_EDM_DRO] Re: encoder Jon Elson 2004-09-25 16:26:34 UTC Re: [CAD_CAM_EDM_DRO] Re: encoder alphawolf45 2004-09-25 16:49:16 UTC Re: encoder mohamed rashwan 2004-09-25 20:28:15 UTC RE: [CAD_CAM_EDM_DRO] encoder wanliker@a... 2004-09-25 20:37:47 UTC Re: [CAD_CAM_EDM_DRO] encoder R Rogers 2004-09-26 07:33:30 UTC Re: [CAD_CAM_EDM_DRO] Re: encoder GRautoHP@a... 2004-09-26 13:39:25 UTC Re: [CAD_CAM_EDM_DRO] Re: encoder turbulatordude 2004-09-26 18:17:48 UTC PMM8714 5 phase stepper driver chip data sheet ?? mohamed rashwan 2004-09-27 06:27:46 UTC Re: [CAD_CAM_EDM_DRO] PMM8714 5 phase stepper driver chip data sheet ?? turbulatordude 2004-09-27 06:49:57 UTC 5 phase stepper driver deprince eddy 2006-02-19 05:36:37 UTC encoder ebiz_59 2008-04-24 10:13:23 UTC encoder David Speck 2008-04-24 10:20:53 UTC Re: [CAD_CAM_EDM_DRO] encoder Jon Elson 2008-04-24 20:13:14 UTC Re: [CAD_CAM_EDM_DRO] encoder stcnc2000 2008-04-25 07:57:45 UTC Re: encoder Mic 2008-04-25 09:42:28 UTC Re: encoder