Re: Servo drives- Mariss

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Polaraligned"
<polaraligned@o...> wrote:

> Mariss, do you have plans for a drive to compete head to head
> with the soon to be released Rutex R2000 servo drive? If so, what
> is the time frame?

What is the point ?

The power that thing can deliver 200 volts, 40 amps will rip the
column off the bridgeport, not just snap a 3/4 cutter.

I'm still not sure about the watts and hp thing. but input is a max
of 8,000 watts, so a 3:1 gearing = 24,000 watts. Now, if you divide
by 1,351 and get 17.76, is that 17.6 hp ? is that a tad bit more than
the 1/8th hp needed to run a Bridgeport ?


SPI interface ? that is someone else's answer to the open-source
G200x project.

It does add brushless servos, but as I see it, that is really the only
big selling point.

A comparison of PID might be interesting.

The tuning software is VERY interesting. I am a little surprized no
one wrote up a proceedure for using the Win-Scope (PC Oscilloscope via
sound card) to tune the G320's.


Dave