Re: [CAD_CAM_EDM_DRO] Sinosidal Encoder signals to TTL signals converter

Stephen Wille Padnos wrote:

>Jon Elson wrote:
>
>
>
>>[snip]
>>
>>
>>This conversion is made with Ohm's law, in the form :
>>Volts = Amps/resistance
>>
>>So, if you divide 11 uAmps by 1000 Ohms, you get
>>.000011 Amp /1000 Ohm= .011 Volt, or 11 mV.
>>If you desire a different voltage, you use a different resistor
>>value.
>>
>>
>>
>>
>Uh - just to point out the thinko in the above paragraph (I know you
>know what you meant, Jon):
>Volts = Resistance * Amps
>

YOW! That what I get for answering email late at night! Thanks for the
correction!

>
>So you have 11 uA, or 0.000011 A * 1000 ohms, which yields the correct
>result of 0.011 V, or 11 millivolts.
>
>

Yes, I calculated it right, but i WROTE it down wrong!

Jon