Re: [CAD_CAM_EDM_DRO] Indexer LPT

Yes, that would be good to know some more info
about the front end. CNCpro and IndexerLPT are
two differant kinds of software. CNCpro is a
finished product with a front end. IndexerLPT is just
code or routines that become part of the software
that you build. You will have to be into programming
to use IndexerLPT.

Steve


----------
From: Carlos Guillermo <carlos@...>
To: CAD_CAM_EDM_DRO@egroups.com
Subject: RE: [CAD_CAM_EDM_DRO] Indexer LPT
Date: Sunday, July 16, 2000 7:39 AM

Byron -

Can you tell us more about your IndexerLPT frontend??

Carlos Guillermo
VERVE Engineering & Design

> -----Original Message-----
> From: BYRON DAMANIA [mailto:byron@...]

> John Stevenson
> Special Purpose Machines
> Nottingham, England>
>
> Dear John Stevenson,
>
> I was browsing through old mail.
>
> Did you finally use Abilities Indexer Lpt ?
>
> I have made a software that runs with G & M codes and uses
> Indexer LPT to run stepper or servo motors
>
> regards
>
> Byron Damania

------------------------------------------------------------------------
Experience MSN...
Get 1 FREE* month of unlimited Internet access!
http://click.egroups.com/1/6323/4/_/423600/_/963758071/
------------------------------------------------------------------------

Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.

Addresses:
Post message: CAD_CAM_EDM_DRO@egroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
Moderator: jmelson@... [Moderator]
URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
FAQ: http://www.ktmarketing.com/faq.html
bill,
List Manager