Re: [CAD_CAM_EDM_DRO] Re: Cleaning Circuit Boards

I cleaned the Boxford TCL 125 PCBs using Armor All Multi-purpose Cleaner. I
just sprayed it into the boards nd allowed it to drain off, taking the
grime with it. A quick rinse under the hot water tap before standing the
boards up in the dish rack on the draining board to dry and the boards
lookas good as new.

snip

>
>I've also used "multi" which is a spray-and-wipe type household cleaner with
>good success then rinsed under a tap and air dried.
>

snip

>
>Cheers, Chris.
>
>* Design engineer, Assembly worker, Cleaner.
>* Ohmark Electronics. PO Box 5302, Christchurch, New Zealand.
>* http://www.ohmark.co.nz
>----- Original Message -----
>From: Smoke <Smoke@...>
>To: <CAD_CAM_EDM_DRO@egroups.com>
>Sent: Monday, November 27, 2000 8:06 AM
>Subject: Re: [CAD_CAM_EDM_DRO] Re: Cleaning Circuit Boards
>
>
>> I'd recommend vacuumn instead of blast. Way back in '75 when I was
>working
>> with electronics, I learned....and "relearned" it again recently in
>computer
>> school...that using an air blast can imbed minute particles in the circuit
>> board(s), possibly causing all kinds of problems that you'd never be able
>to
>> find.
>>
>> with the advent of today micro electronics, I'd suspect the problem would
>be
>> even worse now.
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
>discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager