Re: [CAD_CAM_EDM_DRO] HF Bandsaw converted to CNC

Jon. that sounds a good base,
I am shure the devil is in the neumatics that got clogged up by resin
or worn so it sticks.
If you want to go shure then change to a small PLC .

Jon Anderson wrote:

> Sven,
>
> The reason I'd really like to find a dead automatic saw is because they
> are setup to do precision infeed of materials. Mechanically everything
> is there already. I used to work in a shop that had one controlled by
> air logic. That thing was always messing up, would do things like open
> the vise jaw and try to feed material while the blade was buried in the
> cut! Nobody could figure it out so the owner would sit behind it and
> cuss/swear for hours while tinkering. He'd eventually get it going and
> it'd run for another couple months. Ideally, I'd like to walk in the
> door in the middle of the cuss/swear session, and offer to haul the
> problem away cheap...<G>
> Even in the worst case, it'd be fairly simple to set one of these up to
> run manually while working out the automation. And Pride Saw, an outfit
> that sells and sharpens the blades for these is only 1/4 mile down the
> road from me.
>
> Jon
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

[Non-text portions of this message have been removed]