Re: [CAD_CAM_EDM_DRO] Axis Re-set ?

Hi Hugh,

Right click on the axis display while in manual mode - this will allow you
to set the axis to any figure you want. Occasionally, the axis readings seem
to get 'stuck' thinking they are zeroed when they actually read some other
figure (perhaps this is only on my setup??) In this case, you can go to the
'offsets....' settings in the 'view' menu and find the rogue figure, reset
it to zero and then 'reload values'

Ian
--
Ian W. Wright
Sheffield UK
www.iw63.freeserve.co.uk

----- Original Message -----
From: "Hugh & Denise Currin" <currinh@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: 03 July 2001 11:41
Subject: [CAD_CAM_EDM_DRO] Axis Re-set ?


>
> Here is a simple question for those familiar with EMC. How can I re-set
> the axes to zero? I've looked through the Handbook and NIST pages and
> haven't found this. It looks like G10 might do this but it is not
> documented in enough detail (i.e. EMC wants additional parameters). Other
> than re-starting EMC how do I do this?
>
> I want to jog to a point and then set this as the orgin.
>
> Thank you.
>
> Hugh
> Klamath Falls, OR
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>