Re: EMC problem/question

Tim:

At 02:44 PM 8/4/01 -0600, you wrote:

>Put CNC Pro demo on a bootable DOS floppy and see if you get the same
>results. Because everything is untested you want to obviously get the
>problem isolated. This would be the quickest way to see if it is software.

Thanks, and a very good idea. I did set up the system as a dual boot,
linux/dos, so it wasn't too hard to use other software. With it there was
no drift, dead on. So it must be something in EMC.

Maybe I'll ask the nist list, but their discussions are usually over my head.

Thanks Tim. Any other ideas?

Hugh Currin
Klamath Falls, OR