Re: new members here:) {long}
Posted by
turksfixit
on 2001-12-21 06:15:26 UTC
The upsidedown bandsaw already is being fed at an angle so that the blade cuts up,,,so the tube that the coil slides into is bracing the coil.
know of any sites that tell you how to make an EMD cutter?
i need to know how they work alittle better, voltages, circuts and stuff, my dad can make it.
Cyril
know of any sites that tell you how to make an EMD cutter?
i need to know how they work alittle better, voltages, circuts and stuff, my dad can make it.
Cyril
Discussion Thread
turksfixit
2001-12-21 02:00:50 UTC
new members here:) {long}
ballendo
2001-12-21 04:17:12 UTC
Re: new members here:) {long}
turksfixit
2001-12-21 06:15:26 UTC
Re: new members here:) {long}
Bill Vance
2001-12-21 07:04:46 UTC
Re: [CAD_CAM_EDM_DRO] new members here:) {long}
Scott
2001-12-21 09:42:52 UTC
Re: [CAD_CAM_EDM_DRO] Re: new members here:) {long}
Smoke
2001-12-21 09:58:04 UTC
Re: [CAD_CAM_EDM_DRO] Re: new members here:) {long}
Smoke
2001-12-21 10:02:43 UTC
Re: [CAD_CAM_EDM_DRO] new members here:) {long}
turksfixit
2001-12-21 12:28:59 UTC
Re: new members here:) {long}
turksfixit
2001-12-21 12:31:28 UTC
Re: new members here:) {long}
ballendo
2001-12-22 00:30:14 UTC
wire edm Chain mail was Re: new members here:) {long}
ballendo
2001-12-22 01:30:05 UTC
Re: new members here:) {long}
Sven Peter
2001-12-22 05:23:07 UTC
Re: [CAD_CAM_EDM_DRO] new members here:) {long}
Sven Peter
2001-12-22 05:47:08 UTC
Re: [CAD_CAM_EDM_DRO] Re: new members here:) {long}
Ian Wright
2001-12-22 08:21:09 UTC
Re: [CAD_CAM_EDM_DRO] Re: new members here:) {long}
Ian Wright
2001-12-22 08:21:10 UTC
Re: [CAD_CAM_EDM_DRO] new members here:) {long}
Marcus & Eva
2001-12-22 08:42:23 UTC
Re: [CAD_CAM_EDM_DRO] wire edm Chain mail was Re: new members here:) {long}
turksfixit
2001-12-22 18:25:52 UTC
Re: new members here:) {long}
Ian Wright
2001-12-23 12:57:56 UTC
Re: [CAD_CAM_EDM_DRO] Re: new members here:) {long}
Scott
2001-12-27 06:41:46 UTC
Re: [CAD_CAM_EDM_DRO] Re: new members here:) {long}