Re: [CAD_CAM_EDM_DRO] help with g201 needed

Hi Al,

Sounds like the Gecko's are not getting +5V; they are "stealing" it from
the direction line! What is your +5V supply?

HTH

Alan KM6VV


Al Schoepp wrote:

>
> Hi, hope someone here can help. I've got a Taig micromill converted to CNC
> with 3 G201A's using CNCpro. It was working well before Christmas. I get
> back from holidays and tried to do some work on it and the Z axis only goes
> up, it doesn't matter which direction I try to move it. I swapped the
> cable with the X axis and then the X axis would only go one direction no
> matter which direction I wanted it to move while the Z axis now works
> correctly. I did no changes, or even had anything open since the last time
> I successfully used it. Any suggestions?
>
> Thanks,
> Al