Re: [CAD_CAM_EDM_DRO] help with g201 needed

Alan,

The 5vdc is coming from the keyboard port on the notebook. It was working
before. Just got the repaired unit back and it was the opto.

Al

At 10:28 AM 14/01/2002 -0800, you wrote:

>Hi Al,
>
>Sounds like the Gecko's are not getting +5V; they are "stealing" it from
>the direction line! What is your +5V supply?
>
>HTH
>
>Alan KM6VV
>
>
>Al Schoepp wrote:
> >
> > Hi, hope someone here can help. I've got a Taig micromill converted to CNC
> > with 3 G201A's using CNCpro. It was working well before Christmas. I get
> > back from holidays and tried to do some work on it and the Z axis only goes
> > up, it doesn't matter which direction I try to move it. I swapped the
> > cable with the X axis and then the X axis would only go one direction no
> > matter which direction I wanted it to move while the Z axis now works
> > correctly. I did no changes, or even had anything open since the last time
> > I successfully used it. Any suggestions?
> >
> > Thanks,
> > Al
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

[Non-text portions of this message have been removed]