Re: help with g201 needed

Hi Al,

Rather than messing with the BIOS perhaps it is easier to take it
from the PC power supply. The +5V on my power supply is the red wire.
I wire it to a mono-earphone jack and use that whenever I need a +5V

Ed

--- In CAD_CAM_EDM_DRO@y..., Al Schoepp <schoepp4887@r...> wrote:
> I'll keep this in mind.
>
> Al
>
> At 01:27 AM 15/01/2002 +0000, you wrote:
> >I had the same problem at one point. I increased the MB IO voltage
> >from 3.3v to 3.5 volts and that pesky Z axis ran smoother and ran
in
> >both directions. If you have this option in your bios it may help
> >get that little extra current I think you need to sync the optos.
> >
> >Regards
> >Joe
> >
> >--- In CAD_CAM_EDM_DRO@y..., Alan Marconett KM6VV <KM6VV@a...>
wrote:
> > > Hi Al,
> > >
> > > Sounds like the Gecko's are not getting +5V; they are "stealing"
> >it from
> > > the direction line! What is your +5V supply?
> > >
> > > HTH
> > >
> > > Alan KM6VV
> > >
> > >
> > > Al Schoepp wrote:
> > > >
> > > > Hi, hope someone here can help. I've got a Taig micromill
> >converted to CNC
> > > > with 3 G201A's using CNCpro. It was working well before
> >Christmas. I get
> > > > back from holidays and tried to do some work on it and the Z
> >axis only goes
> > > > up, it doesn't matter which direction I try to move it. I
> >swapped the
> > > > cable with the X axis and then the X axis would only go one
> >direction no
> > > > matter which direction I wanted it to move while the Z axis
now
> >works
> > > > correctly. I did no changes, or even had anything open since
> >the last time
> > > > I successfully used it. Any suggestions?
> > > >
> > > > Thanks,
> > > > Al
> >
> >
> >Addresses:
> >FAQ: http://www.ktmarketing.com/faq.html
> >FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> >
> >Post messages: CAD_CAM_EDM_DRO@y...
> >Subscribe: CAD_CAM_EDM_DRO-subscribe@y...
> >Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@y...
> >List owner: CAD_CAM_EDM_DRO-owner@y..., wanliker@a...
> >Moderator: jmelson@a... timg@k... [Moderator]
> >URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> >bill,
> >List Manager
> >
> >
> >
> >Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
>
>
> [Non-text portions of this message have been removed]