Re: [CAD_CAM_EDM_DRO] help with g201 needed

Al,

When you say you swapped the cable, did you swap the input to
the drive or the output to the motor. If you swapped the input then it
sounds like the wire that sends the direction signal to the drive
has opened on that axis.

Bill

> Hi, hope someone here can help. I've got a Taig micromill converted to

CNC

> with 3 G201A's using CNCpro. It was working well before Christmas. I get
> back from holidays and tried to do some work on it and the Z axis only

goes

> up, it doesn't matter which direction I try to move it. I swapped the
> cable with the X axis and then the X axis would only go one direction no
> matter which direction I wanted it to move while the Z axis now works
> correctly. I did no changes, or even had anything open since the last

time

> I successfully used it. Any suggestions?
>
> Thanks,
> Al
>
>
> [Non-text portions of this message have been removed]
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>