Re: [CAD_CAM_EDM_DRO] Re: help with g201 needed

I'll keep this in mind.

Al

At 01:27 AM 15/01/2002 +0000, you wrote:

>I had the same problem at one point. I increased the MB IO voltage
>from 3.3v to 3.5 volts and that pesky Z axis ran smoother and ran in
>both directions. If you have this option in your bios it may help
>get that little extra current I think you need to sync the optos.
>
>Regards
>Joe
>
>--- In CAD_CAM_EDM_DRO@y..., Alan Marconett KM6VV <KM6VV@a...> wrote:
> > Hi Al,
> >
> > Sounds like the Gecko's are not getting +5V; they are "stealing"
>it from
> > the direction line! What is your +5V supply?
> >
> > HTH
> >
> > Alan KM6VV
> >
> >
> > Al Schoepp wrote:
> > >
> > > Hi, hope someone here can help. I've got a Taig micromill
>converted to CNC
> > > with 3 G201A's using CNCpro. It was working well before
>Christmas. I get
> > > back from holidays and tried to do some work on it and the Z
>axis only goes
> > > up, it doesn't matter which direction I try to move it. I
>swapped the
> > > cable with the X axis and then the X axis would only go one
>direction no
> > > matter which direction I wanted it to move while the Z axis now
>works
> > > correctly. I did no changes, or even had anything open since
>the last time
> > > I successfully used it. Any suggestions?
> > >
> > > Thanks,
> > > Al
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

[Non-text portions of this message have been removed]