Re: [CAD_CAM_EDM_DRO] DeskWinNC vs Flashcut?

I have been told that there is a known issue with circular moves if the axes
do not have the same steps per inch. I have not run into this problem
personally as my machine has equal steps on X and Y. Also the controller is
3 axis only. I have tested with it, but keep going back to EMC as my
favorite, but I am using Gecko G320 drives where the EMC pulse train does
not cause a problem. If I was using steppers my answer may be different. I
have no experience with Flashcut.

Tim
[Denver, CO]
Stepper motors, drives, and encoders
http://www.KTMarketing.com/CNC.html

----- Original Message -----

> Hi all,
>
> Does anyone have any experience with DeskWinNC?
> How does it compare to Flashcut or EMC?
> Any info would be greatly appreciated!
>
> Regards,
> Peter Leijnen
> Leijnen Engineering
>
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/