Steppers

I hate to ask the same questions, but I still don't know which way is the most economical way to go.

I have a piece of iron which has 840 oz.in. steppers and encoders already mounted on all 3 axis.

I would like to use what I have because of the cost of replacement.

I am not an electronics man. I can follow instructions. I can not design any electronic circuits.

Is there a place I can get instructions for any of the ideas which get batted around in this group? Not design instructions, but instructions on what is needed and where to get it.

If I offend anyone by wanting to use steppers instead of servos, just remember I already have the steppers and they are mounted.

Thanks again.

Charles Hopkins