Re: high-performance EDM power supply

Well I'm in!

I offer my limited electronics knowledge e.g. a modern electronics
degree :) as well as the knowledge of some friends who do power
electronics and spend a lot of time shoving big volts and amps at
massive motors and design the controllers to do so.

As for software, once you register TurboCNC then you get the source
code which might be modified for wire edm, reversing the tool path
would involve just flipping the directions of z and y plus other
stuff. For a sink machine then you could start from scratch assuming
single axis.

I say don't worry about the software and get the design underway.

Graham