RE: [CAD_CAM_EDM_DRO] Re: Clarifications needed -

> Would you and others recommend I have it lower?
>
> I'm not sure at this point if it makes a difference, but all
> three motors ( with a fourth later) run off of this voltage.
> I'm guessing, but it seems possible to have all three axis' drawing
> off of the output voltage at once, making each get 1/3
> available... Or am I thinking of this incorrectly?

Each motor and drive will see the full voltage. It is not reduced by
connecting more (unless you did it in series and that would be a bad
thing). I would recommend you aim for about 60 - 65 VDC. That give you a
good amount of headroom and will still give you great performance.

Tim
[Denver, CO]
Beat the Sherline Oct 1 price increase. Order Now!
New Sherline Prices at http://www.ktmarketing.com/SherlineIncrease.htm

Sherline & Taig products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline
e-mail me at Timg @ KTMarketing.com for items not yet listed