Re: 1720XMTC shoptask z axis Ballscrews

They're scattered in various archive directories. The though was that the site might disappear like Chuck's website and this way they would be in more than one place.

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Ron Thompson <barebooger@...> wrote:
>
> On 1/2/2011 3:52 PM, jimmy_staton wrote:
> >
> > Ok I found a bunch of various project photo of Chuck McGhee's about
> > 3.4 Meg of jpegs I could post if that's allowed? They're from
> > Metalworking.com dropsite.
> > None are of the later Z axis, though one shows his toolpost turret and
> > the driven ballnut is probably the same!
> >
> Why not just post a link?
>
> --
>
>
> Ron Thompson
> On the Beautiful Florida Space Coast, right beside the Kennedy Space Center, USA
>
> There are two kinds of posts on newsgroups.
> 1. This is what I have done...
> 2. This is what I think...
> Be aware of the difference!
>
> http://www.ourcadguy.com/
>
> http://www.plansandprojects.com My hobby pages are here:
> http://www.plansandprojects.com/My%20Machines/
>
> Visit the castinghobby FAQ:
> http://castinghobbyfaq.bareboogerhost.com/
>
>
>
>
>
>
>
>
> [Non-text portions of this message have been removed]
>