Re: [CAD_CAM_EDM_DRO] USB options ...

 

On 18/06/14 19:31, thom@... [CAD_CAM_EDM_DRO] wrote:
> I contend that you won't find critical commercial systems running USB.
> If you are a DIY hobby guy and don't mind living with an occasional
> disconnect or "glitch" then USB might be acceptable.

Since the Computer sits on top of the controller I'm only running
perhaps a foot of ribbon or USB cable which would seem to assist in
preventing some of the problems people are describing. I've killed
everything on the computer other than Mach3 as even though these are
'light industrial' there is no reason to use the machine fore anything else.

> As you may or may not know, when you move to ANY external pulse card
> with MACH you become "disconnected" from real time motion so it rules
> out any feedback type operations like THC to MACH
> We recently introduced a new ultra high speed DTHC IV product that no
> longer uses the MACH THC logic and inputs. Shortly thereafter we
> announced our Ether-Cut series that uses Ethernet, runs MACH in WIN7
> 32/64 and has expanded I/O and improves motion versus a parallel port.
> We still sell parallel port solutions but virtually all our new sales
> are the Ether-Cut products. Just the fact the choice of PC platform is
> not as narrow and (just for fun) we ran a plasma table on a laptop with
> WIN 7 and surfed the net. Not something I advise but it proved a point.

I'm having a little trouble identifying the options available for 'Taig'
size machine control. I keep hitting 'Torch Height Control' ... Do you
do an Ether-Cut package which would support 3or4 steppers via step and
direction?

--
Lester Caine - G8HFL
-----------------------------
Contact - http://lsces.co.uk/wiki/?page=contact
L.S.Caine Electronic Services - http://lsces.co.uk
EnquirySolve - http://enquirysolve.com/
Model Engineers Digital Workshop - http://medw.co.uk
Rainbow Digital Media - http://rainbowdigitalmedia.co.uk