Re: Smart/Dumb box again...

Doug, List,

I believe MaxNC alrerady IS set up to deal with a separate GUI. This
was discussed in the past on this list. They (Otto) did it for The
Motion Group (TMG) in San Jose, CA. He had mentioned to me at one
point doing it (adding "hooks" to the guts of the control) for a
Canadian company as well, but Otto can be very evasive at times...

Hope this helps.

Ballendo

>It would be great if we could talk Doug Yeager into coding cncpro
>for this type of remote access.
> Doug