re:backlash comp was Re: Climb Milling (again)

Doug,

While I can certainly imagine cuts which "could" move that 500 lb.
table, your point is well taken...

Ballendo

--- In CAD_CAM_EDM_DRO@y..., dougrasmussen@c... wrote:
> Also, it seems some here are thinking in terms of large amounts of
> backlash. When I got my biggest mill it had pre-entered values of
> less than .0005" for X,Y,Z from the factory. Since the X table on
> that machine must weigh well over 500 pounds it's hard to imagine
any
> cutter could make it "jump" under normal conditions.
>
> thanks,
>
> Doug