Re: [CAD_CAM_EDM_DRO] Flat Holes

You can make hole with a drill bit and finish it off
with an END MILL.
H.B.Shah
--- "Carey L. Culpepper" <culpeppe@...>
wrote: > Just use an end mill after drilling the pilot
hole.

> Carey
>
> gm4ta@... wrote:
>
> > Is there a special type of drill bit to make holes
> with perfectly
> > flat bottoms? All the drill bits I see are
> somewhat tipped. I want to
> > make flat-bottomed holes so I can recess socket
> head cap screws.
> >
> > -GM4T
> >
> > Addresses:
> > FAQ: http://www.ktmarketing.com/faq.html
> > FILES:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> >
> > Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> > Subscribe:
> CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> > Unsubscribe:
> CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> > List owner:
> CAD_CAM_EDM_DRO-owner@yahoogroups.com,
> wanliker@...
> > Moderator: jmelson@...
> timg@... [Moderator]
> > URL to this page:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> > bill,
> > List Manager
> >
> >
> >
> > Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe:
> CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe:
> CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com,
> wanliker@...
> Moderator: jmelson@...
> timg@... [Moderator]
> URL to this page:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>

___________________________________________________________________
*NEW* Yahoo! Messenger for SMS. Now on your Celforce phone *NEW*
Visit http://in.mobile.yahoo.com/smsmgr_signin.html