Re: [CAD_CAM_EDM_DRO] Re: Flat Holes

> The bottom will have a cutting action if you'll file a relief angle on the
> bottom of the flutes as I mentioned once before. And yes, it does matter.
>
> If your worried about the work "grabbing the tool, and all those other
> points made where it's been said not to use an end mill in the drill
> press...just clamp the work securely and work slowly.
>
> Smoke
>
> > You got it 100%. I only have a drill press. I think I'm going to use
> > the 2 drills method now. But if I grind flat the bottom, then the
> > bottom won't have any cutting action. Would that matter since it's
> > going to cut a little bit anyways?
> >
> > -GM4T
> >
> >
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>