Re: I want to upgrade to servors

I think that is a file used for MsDos.. do you deleted or edit it?



--- In CAD_CAM_EDM_DRO@y..., "Carol & Jerry Jankura"
<jerry.jankura@s...> wrote:

>
> I'm running the same software and using the Camtronics 2 amp

controller. My

> motors are the Sherline 100 oz-in units.
>
> I had a similar problem with the motors not wanting to turn very

fast, until

> I found that the EMM386.EXE driver was causing the pulse train to be
> unstable. Once I eliminated the EMM386.EXE driver from my

Config.SYS file, I

> was able to run the motors at high speed. You might want to give

that a try.

>
> -- Jerry
>
> |I am using turboCNC for software,250 oz 4v 2amp steppers brand
> |eastern air device and the camtronic controller.. I have tried
> |several settings like min speed, max speed and I could not getting
> |faster.. the steppers locking up or loose step if I run it faster
> |tried other softwares and nothing better so I decided to go for
> |servo.. any suggestions??