Re: I want to upgrade to servors/ EMM386.EXE

I checked my two computers and there is not such line that call
EMM386.EXE on my CONFIG.SYS file..

The following is the copy of the CONFIG.SYS:

[menu]
menuitem=HELP, Help
menuitem=CD, Start computer with CD-ROM support.
menuitem=NOCD, Start computer without CD-ROM support.
menuitem=QUICK, Minimal Boot
menudefault=HELP,30
menucolor=7,0

[HELP]
device=oakcdrom.sys /D:mscd001
device=btdosm.sys
device=flashpt.sys
device=btcdrom.sys /D:mscd001
device=aspi2dos.sys
device=aspi8dos.sys
device=aspi4dos.sys
device=aspi8u2.sys
device=aspicd.sys /D:mscd001
devicehigh=ramdrive.sys /E 2048

[CD]
device=oakcdrom.sys /D:mscd001
device=btdosm.sys
device=flashpt.sys
device=btcdrom.sys /D:mscd001
device=aspi2dos.sys
device=aspi8dos.sys
device=aspi4dos.sys
device=aspi8u2.sys
device=aspicd.sys /D:mscd001
devicehigh=ramdrive.sys /E 2048


there is not a line calling EMM386.exe




--- In CAD_CAM_EDM_DRO@y..., "Michael Milligan" <mmmilligan@f...>
wrote:

>
> EMM386.EXE is used by MSDOS as an Extended Memory Manager and is
> required by quite a few DOS applications which use memory outside
> the standard DOS segment.
>
> Adding the word 'REM ' at the start of the line will convert the
> line from being a Code line to being a Comment line. EMM386.EXE
> will not be configured and any reliant DOS application will cease
> to operate.
>
> Regards
> Michael
>
> -----Original Message-----
> From: Carol & Jerry Jankura [mailto:jerry.jankura@s...]
> Sent: 16 February 2002 09:07
> To: CAD_CAM_EDM_DRO@y...
> Subject: RE: [CAD_CAM_EDM_DRO] Re: I want to upgrade to servors
>
>
> Neither, I just commented the line that invokes it in CONFIG.SYS.

Don't

> delete it, as you might want it for other applications of the

computer.

> Simply open CONFIG.SYS in your editor and add the word "rem " at

the start

> of the line that calls EMM386.EXE.
>
> |I think that is a file used for MsDos.. do you deleted or edit it?
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@y...
> Subscribe: CAD_CAM_EDM_DRO-subscribe@y...
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@y...
> List owner: CAD_CAM_EDM_DRO-owner@y..., wanliker@a...
> Moderator: jmelson@a... timg@k... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to

http://docs.yahoo.com/info/terms/