CAD CAM EDM DRO - Yahoo Group Archive

Re: help

on 2003-03-15 12:10:03 UTC
1 Clock1
2 Set1
3 Reset1
4 J1
5 Vcc
6 Clock2
7 Set2
8 Reset2

9 J2
10 Qnot2
11 Q2
12 K2
13 Gnd
14 Qnot1
15 Q1
16 K1

Or try http://www.onsemi.com/pub/Collateral/SN74LS76A-D.PDF
This is for the 74LS76 but it's the same pinout.

Mariss

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Richard" <phrh@w...> wrote:
> I need the pinout for a 7476 16 pin dip IC. Can anyone help? RNH

Discussion Thread

Ros 2000-03-25 21:40:26 UTC help riet91@y... 2001-08-09 02:26:28 UTC help mabw 2002-05-26 17:18:54 UTC re:help William Scalione 2003-03-15 11:27:15 UTC Re: [CAD_CAM_EDM_DRO] help Richard 2003-03-15 11:44:30 UTC Re: help Mariss Freimanis 2003-03-15 12:10:03 UTC Re: help frank_kandl 2003-09-10 07:34:42 UTC help Jon Elson 2003-09-10 09:41:53 UTC Re: [CAD_CAM_EDM_DRO] help Michael Milligan 2003-09-10 16:16:19 UTC RE: [CAD_CAM_EDM_DRO] Dolphin CAD CAM Plus Mach2 Mill Gary Davison 2004-07-19 18:58:56 UTC help Andy Wander 2004-07-19 19:20:50 UTC RE: [CAD_CAM_EDM_DRO] help Gary Davison 2004-07-19 19:33:49 UTC Re: help Fred Smith 2004-07-19 20:29:43 UTC Re: help Fred Smith 2004-07-19 20:47:12 UTC Re: help Gary Davison 2004-07-20 06:51:28 UTC Re: help Art Eckstein 2004-07-20 07:12:34 UTC Re: [CAD_CAM_EDM_DRO] Re: help Gary Davison 2004-07-20 08:12:10 UTC Re: help Alan Marconett 2004-07-20 09:29:25 UTC Re: [CAD_CAM_EDM_DRO] Re: help Art Eckstein 2004-07-20 11:06:53 UTC Re: [CAD_CAM_EDM_DRO] Re: help Alan Marconett 2004-07-20 11:23:12 UTC Re: [CAD_CAM_EDM_DRO] Re: help Gary Davison 2004-07-20 15:09:06 UTC Re: help Andy Wander 2004-07-20 15:28:22 UTC RE: [CAD_CAM_EDM_DRO] Re: help