Re: [CAD_CAM_EDM_DRO] help
Posted by
Jon Elson
on 2003-09-10 09:41:53 UTC
frank_kandl wrote:
motors. Are there separate encoders for each X motor? The only tricky
part is to get the motors in sync before the Geckos are turned on.
Jon
>Could anybody recommend me suitable drivers and SW for my bridgeI suspect that the Gecko 320 would work. I assume these are DC brush
>plotter with dual X servo motors and 1 Y servo motor with 600 CPR
>encoder which I would like to expand for Z motor to use plotter as
>router etc.
>
>
motors. Are there separate encoders for each X motor? The only tricky
part is to get the motors in sync before the Geckos are turned on.
Jon
Discussion Thread
Ros
2000-03-25 21:40:26 UTC
help
riet91@y...
2001-08-09 02:26:28 UTC
help
mabw
2002-05-26 17:18:54 UTC
re:help
William Scalione
2003-03-15 11:27:15 UTC
Re: [CAD_CAM_EDM_DRO] help
Richard
2003-03-15 11:44:30 UTC
Re: help
Mariss Freimanis
2003-03-15 12:10:03 UTC
Re: help
frank_kandl
2003-09-10 07:34:42 UTC
help
Jon Elson
2003-09-10 09:41:53 UTC
Re: [CAD_CAM_EDM_DRO] help
Michael Milligan
2003-09-10 16:16:19 UTC
RE: [CAD_CAM_EDM_DRO] Dolphin CAD CAM Plus Mach2 Mill
Gary Davison
2004-07-19 18:58:56 UTC
help
Andy Wander
2004-07-19 19:20:50 UTC
RE: [CAD_CAM_EDM_DRO] help
Gary Davison
2004-07-19 19:33:49 UTC
Re: help
Fred Smith
2004-07-19 20:29:43 UTC
Re: help
Fred Smith
2004-07-19 20:47:12 UTC
Re: help
Gary Davison
2004-07-20 06:51:28 UTC
Re: help
Art Eckstein
2004-07-20 07:12:34 UTC
Re: [CAD_CAM_EDM_DRO] Re: help
Gary Davison
2004-07-20 08:12:10 UTC
Re: help
Alan Marconett
2004-07-20 09:29:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: help
Art Eckstein
2004-07-20 11:06:53 UTC
Re: [CAD_CAM_EDM_DRO] Re: help
Alan Marconett
2004-07-20 11:23:12 UTC
Re: [CAD_CAM_EDM_DRO] Re: help
Gary Davison
2004-07-20 15:09:06 UTC
Re: help
Andy Wander
2004-07-20 15:28:22 UTC
RE: [CAD_CAM_EDM_DRO] Re: help