Re: Best source for Servo's ?? threads and learning

> Are these Servo Motors?
>
> I am very interested in this thread as I too
> what to start working on a Design/Building
> a CNC Plasma Cutter from the bottom up.
>
> I am new to this Forum and this is my first post.
> My electrical skills are Very Very weak. But I look
> forward to learn enough about Servo, power supplies, controllers,
> and whatever else I need to learn to build this.
>
> Any threads I shouls read to fill me in and
> advise me in the pre-process of the begining
> of this build would be great.
>
> Luke

Hi Luke,

Welcome to the list.

I have what I think are the best posts from this thread on a single
file. I'll be back at my PC on Tuesday so will send you a copy. It
includes all the post numbers so you can check the threads too.

I am working on another one about sizing the table and motors. also,
a collectoin from the archives. That is still in the formative
satages.

All will wind up in the files section, but I will be asking some of
the guys to review for correctness before puting it there for
posterity.

I have not mentioned this except in passing, but I'll put your name
on the 'send me a copy' list. All people being quoted (intact full
posts are used, not snips) will be copied as it is their words too.
Of course it will be open to anyone else.

I've done work on the water table design so when you get to that
point, I can offer that to you as well.


But, if you want to get a look at the archives of this list, google
pgoffline for a software that will let you pull the archives of the
whole list onto your PC for much faster searches of the list.

Dave
Moderator