Re: [CAD_CAM_EDM_DRO] What is prefered connector for steppers to control box?

At 07:01 24/12/2005, you wrote:

>At 06:42 24/12/2005, you wrote:
> >many people have used 5-pin XLR connectors, although they generally don't
> >have gold. I prefer gold for long-term reliability. Some people also use
> >DB-9 or DB-15 connectors, which are quite good, and can be had
> >inexpensively.
>
>I use 4-pin XLR connectors (no particular point in having 5 pins unless you
>are running unipolar, and the pins/solder buckets are bugger than on the
>5-pin). The XLR connectors have a good current rating and the solder
>buckets will take sensible sized conductors.
>
>I wouldn't personally use the D-type connectors for step motor power - the
>pins & solder buckets are too small to take the size of conductor that you
>are likely to use (should use) for wiring up steppers & the close spacing
>between the pins seems to be a recipe for creating shorts. Can't say I am
>too keen on them for signal connection either, unless I can use the IDC
>varieties to avoid having to solder them.

Oops...nasty slip of the keys...that should of course read "and the
pins/solder buckets are bigger..."

Regards,
Tony