Re: HTD belts vs GT2 on Bridgeport

<snip>

> The 18 tooth pulley is a bit over 1-1/16" diameter with a 1/4"
> shaft. I am going to stick the armature of the Baldor servos
> in my lathe and turn the end down to 1/4".

I was wrong on the bore and pulley size. I have a 10 tooth, 3/8 shaft
XL pulley. so, you would be able to open an 18 tooth up pretty big.

When you get the pulley, measure everything. I would open the pulley
bore before reducing the motor shaft. A 1/4 shaft will not be very
strong.

Measure everything when you get all the pieces in the shop.

Dave