Re: New Article Posted

Just looked it up...
Phil purchased a 4 axis driver board from us on October 30th, 2005.
This explains the same value sense resistors we use. Not sure what
values Ballendo's version uses. Maybe he can tell us?

Dave Rigotti
HobbyCNC.com

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "turbulatordude"
<dave_mucha@...> wrote:

>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "Dave Rigotti" <drigotti@>
> wrote:
> >
> > What driver chip do you use?
> >
> > Dave
>
>
> If you look at the board, you can see the pin-out. that should

look

> familiar !
>
> Dave
>