Re: [CAD_CAM_EDM_DRO] RE: Lighted edge finder

In a message dated 10/9/00 10:22:41 AM Pacific Daylight Time, KM6VV@...
writes:

<< two other attachments is the set, a ball on a straight rod, and a ball
on a 45 deg. rod. Any ideas? >>
The ball is used the same as the disk, get the ball running true by pushing
with a wood stick (fingernail if you are foolish or daring) then bring the
ball to the edge of the work and when it flies out the spindle is at the edge
plus half the diameter of the ball. The ball on the end of the 45 degree arm
is there to fill the empty pocket in the holder, No that is not right!! I
know there is a valid use for it, and have read directions but I just don't
remember what it is.
John Meacham
(who very seldom has a senior moment, but this is one of them)