RE: [CAD_CAM_EDM_DRO] CAM Software: Opinions Wanted

I personally use EMC, but if you want to eliminate that one here is my run
down:

MaxNC No experience, but was advised by experienced users that it has many
restrictions and quirks.
SuperCAM No Experience or comment
DanCAM Used it to start with. It works and it is free, but does not accept
g-code and is pretty dated
DeskNC Been there, done that, was disappointed with major resonance
problems and motor stalling
CNC Pro No experience, but very positive feedback on the list

Tim
[Denver, CO]

> I'm going to need some NC software for use with my new Camtronics
> controller and mill/drill conversion. I've seen various posts
> over the
> months regarding software, but I haven't seen a good rundown or a
> bunch of opinions.
>
> What do people think is the best software for the money right
> now? I'd
> like to be able to do as much as possible: 2D (from DXF or HPGL), 3D
> surfaces (DXF or IGES?), drilling, engraving (from TrueType)etc.
>
> Here are the packages I'm aware of right now (Excluding the monsters
> like Pro/E, I-DEAS, etc.)
>
> MaxNC
> SuperCAM
> DanCAM
> DeskNC
> CNC Pro
>
> What thinkest thou?
>
> Thanks,
> Jeff
>
> FAQ: http://www.ktmarketing.com/faq.html
>