Re: [CAD_CAM_EDM_DRO] Re: CAM Software: Opinions Wanted

Hey...now THAT'S good information....thanks a bunch! I'll have to try that.
I'm no where near an expert on Rhino.

Right now I'm using the MDX 15 for the scanning but eventually I want to
mount a probe on either one of the two machines I'm converting or on the new
ones I'm building so I'll be able to scan some larger artwork. 4" x 6" is
pretty small.


As for milling the areas I want to reach...that should be pretty easy as
most of the work is going to be on cylinders or truncated cones with the
gcode set up to mill only in the X-Z direction (along the cylinder/cone
axis) and the part rotated in very small increments using a forth axis.


Smoke

>
>The most important thing I need is not a CAD program (I use Rhino) but a
>program that will take a complex bas-relief surface that has been "scanned"
>into the computer, saved as a .dxf or .stl or ??? file, wrap or project

this

>to a curved (possibly a complex curve) and then generate a GOOD gcoed for
>machining. By GOOD I mean one that doesn't have to be "tweaked"
>considerably to make it work.
>
>Smoke
>
>[These scans are coming from your Roland MDX-15? If so, what I've found
>most effective is to use Rhino's "Drape" command to convert these to NURBS
>surfaces, then do the wrapping, flowing, etc. in Rhino. You use it by
>first maximizing the top view and making the image almost fill the screen,
>Then drag a box around the whole thing to create a "vacuformed" surface
>over your original scan. You can then delete the polygon mesh. Detail will
>be a bit softer, but the file will take up fewer bytes. This NURBS surface
>can be trimmed if necessary. To make it conform to a curve, first draw a
>straight line along the axis of the surface you want to bend. Then draw the
>curve you want to project to (direction matters, so if it comes out
>backwards, flip the curve direction and try again). Highlight the surface,
>then using the "Flow" command pick first the straight line (original
>backbone curve) and next your curve.
>
>Once the geometry is how you want it, export it as a DXF or STL, then use a
>g-code converter like MillWizard or DeskProto to write the toolpath. Of
>course, if you bent it very much, it might be hard for a 3-axis mill to
>reach all the areas you want carved- but you knew that already, right...]
>
>www.computersculpture.com
>
>Andrew Werby - United Artworks
>Sculpture, Jewelry, and Other Art Stuff
>http://unitedartworks.com
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>FAQ: http://www.ktmarketing.com/faq.html
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>