Re: [CAD_CAM_EDM_DRO] Souces of Timing/Drive Pulleys

>
> Mike Gann wrote:
>
> > I have been slowly gathering the parts for a retrofit of a small
> > knee mill. The table size and travel is about equivalent to a
> > mill/drill - 6" X 20" (size&travel).
> >
> > I will be fitting it with ball screws. And I am looking for a
> > 2 to 1 drive reduction.
> >
> > Now to my question -
> >
> > What have all you guys been using as a source for your
> > timing pulleys'?
>
> I use W. M. Berg. They may not be the cheapest, but they have an amazing
> variety of belts and sprockets. They make a huge variety of steel-core
> belts that I have used in all sorts of instruments and drives, as well as the
> standard power transmission belts. See them at http://www.wmberg.com/
> But, I kind of like their paper catalogs when I'm picking parts out and figuring
> how long the belts need to be.
>
> Jon
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/