Re: [CAD_CAM_EDM_DRO] Re: Black box again

Joel,

I think the Ah ha based computer can be connected to another machine pretty
easily if you know how. I remember talking to Mike Johnson at Ah Ha about
it, and he told me it really ran slick. I don't think the configuration was
documented, however, and unfortunately, since Ah Ha's wonderful support
staff has been more than decimated, I don't know how much trouble it would
be to find out how to do it. Hopefully someone out there can help.

Tom

----- Original Message -----
From: <joelulaw@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Tuesday, June 26, 2001 9:20 AM
Subject: [CAD_CAM_EDM_DRO] Re: Black box again


> JOHN,
>
> I hobby at home and my design computer is upstaris while my mill is
> in the basement. By the time I create a CAM file, copy to floppy,
> walk downstairs, copy the file to my control computer and find that I
> have made a mistake, I almost forget what I am there for.
>
> I would like to at least make changes in the file and retry without
> all the hassel. Even if I design upstairs I could network both
> together and have the files available when I need to make changes.
>
> I like the AHHA controller and it works very well but I cannot EASILY
> connect both computers together and operate like I would like.
>
> I have tried to install linux four times without success and figure
> that EMC will not be the answer.
>
> Joe
>
>
> > Out of interest why are you looking for a windows type controller
> if
> > you have already got an Ahha controller?
> >
> > True I'll grant you that the display is a bit bland but so are a
> lot
> > of propiatary controllers like Fanuc etc but they still do the job.
> > So far as far as I can see, and I would like anybody to correct me,
> > the Ahha controller has the most features available on the low cost
> > controllers.
> >
> > John Stevenson
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>