Re: Black box again

JOHN,

I hobby at home and my design computer is upstaris while my mill is
in the basement. By the time I create a CAM file, copy to floppy,
walk downstairs, copy the file to my control computer and find that I
have made a mistake, I almost forget what I am there for.

I would like to at least make changes in the file and retry without
all the hassel. Even if I design upstairs I could network both
together and have the files available when I need to make changes.

I like the AHHA controller and it works very well but I cannot EASILY
connect both computers together and operate like I would like.

I have tried to install linux four times without success and figure
that EMC will not be the answer.

Joe

> Out of interest why are you looking for a windows type controller

if

> you have already got an Ahha controller?
>
> True I'll grant you that the display is a bit bland but so are a

lot

> of propiatary controllers like Fanuc etc but they still do the job.
> So far as far as I can see, and I would like anybody to correct me,
> the Ahha controller has the most features available on the low cost
> controllers.
>
> John Stevenson