RE: [CAD_CAM_EDM_DRO] Dual booting w/EMC

Dave,
I was having problems with the MBR... so what should I do?
Steps?
-Chris

-----Original Message-----
From: dlantz@... [mailto:dlantz@...]
Sent: Thursday, December 13, 2001 10:48 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: RE: [CAD_CAM_EDM_DRO] Dual booting w/EMC

if your concerned about the master boot sector getting messed up (as it
sounds like what has happended) you can have the BDI not write to the
master
boot cycle (it's in the install stuff somewhere) and just create a boot
floppy, then when you want to boot linux, reboot the machine with the
floppy
in the drive (assuming bios is setup to boot from floppy 1st)
that is what i have done here
--Dave L.

-----Original Message-----
From: Chris Clough [mailto:cclough@...]
Sent: Thursday, December 13, 2001 8:45 AM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: [CAD_CAM_EDM_DRO] Dual booting w/EMC


Hi all,
Got a quick question... a couple weeks ago I tried to dual boot
Windoze 98 and Linux w/EMC installed - it failed miserably and I ended
up reformatting everything.
Anyone have a simple way to get a Linux partition and swap w/o
screwing up the Windoze partition? Partition Magic then...?
Let me know, KCAM is really cool, but I need something a little more
powerful (EMC)
Thanks,
-Chris Clough



Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager



Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/

Addresses:
FAQ: http://www.ktmarketing.com/faq.html
FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
Moderator: jmelson@... timg@... [Moderator]
URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
bill,
List Manager



Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/