Re: [CAD_CAM_EDM_DRO] Roller Bearings link ? ( was Bad Bearing ( was Re: stuck stepper

At 06:10 PM 9/13/02 -0000, you wrote:

>When you get the new bearing here's a little trick I use to get a
>press fit in a slightly too large hole. Put the housing in a vise
>and use a center punch to create a series of divots around the inside
>of the bearing seat. These divots will displace some metal up and
>allow you to press in a new bearing in a slightly too large hole.

Not really reliable ... knurling is better. But the raised metal is way low
in surface area and will often simply fret away or be pushed back down.

Regards, Hoyt McKagen


Belfab CNC - http://www.freeyellow.com/members/belfab/belfab.html
US Best MC - http://www.freeyellow.com/members/batwings/best.html
Camping/Caving - http://www.freeyellow.com/members/batwings/caving.html
93% of people killed in workplace accidents are men