Re: Yeager CNC Pro and relay settings

Hi Mark,

Still got a couple of problems, I get 5 volts with the meter at the
end of wires (pin 1 and the + 5 volts ) when the M03 command is
activated and goes off when M05 is activated.
When the SSR is then connected the LED goes on and off as it should.

There is nothing at the output side of the SSR, or am I testing it
wrong? it does not go when it is connected to the solenoid either.
Is the pull up resistor needed or is it working correctly up to the
input side of the SSR?

Maybe the SSR is faulty.

Any ideas?

Thanks

Shelby





--- In CAD_CAM_EDM_DRO@yahoogroups.com, "markpowerplus" <mabw@b...>
wrote:

> Hi!
> I am using the same setup almost and I could not get my solenoid

to

> work without the pull up resistor, after putting the resistor in

it

> works a charm.
> Mark
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "shelbyshepherd2002"
> <cabrillo_shepherd@m...> wrote:
> > Hi all,
> >
> > I need some help on the settings within CNC pro for a solid

state

> > relay to activate a solinoid.
> > It is using pin 1 to the neg on the relay and 5 volt to positive
> > from games port, should it be set on high or low?
> > This is the sample G code I used to test with but the relay did
> not
> > appear to work.
> >
> > G01 X5 Y5
> > M01 (to turn on)
> > M0 (to turn off)
> > X0 Y0
> >
> > Any ideas welcome on settings or a sample G code to test with.