Re: [CAD_CAM_EDM_DRO] Yeager CNC Pro and relay settings

First, Pin 1 should be +5 V when it is turn on (set high when enabled). The
negative should go to the logic ground.
Don't forget to put small resistance ( I use 0.5-1 ohm resistor). Just in
case you short your parallel port output.

Second, to turn on the Output 1 the G code should be M03, while to turn off
the Output 1 the G code is M05.

Fortino

----- Original Message -----
From: "shelbyshepherd2002" <cabrillo_shepherd@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, July 31, 2003 4:53 PM
Subject: [CAD_CAM_EDM_DRO] Yeager CNC Pro and relay settings


> Hi all,
>
> I need some help on the settings within CNC pro for a solid state
> relay to activate a solinoid.
> It is using pin 1 to the neg on the relay and 5 volt to positive
> from games port, should it be set on high or low?
> This is the sample G code I used to test with but the relay did not
> appear to work.
>
> G01 X5 Y5
> M01 (to turn on)
> M0 (to turn off)
> X0 Y0
>
> Any ideas welcome on settings or a sample G code to test with.
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>