Re: [CAD_CAM_EDM_DRO] Re: M57-102 < - - - - > PC

m0nkey0ne wrote:

>>
>>
>
>The information I found was in the obsolete section at
>http://www.compumotor.com/manuals/literature_user.htm . They had
>that particular motor number listed. The information did not tell me
>much...more of a user manual rather than installation sheet.
>TA Randy
>
>
>
>

The step/direction inputs are given on Page 17 of that manual.
It is a stepper after all. Most confusing that a later series of
servo motors alse used the M series designation.

Jon