Re: linear bearing based on ground flat stock

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Graham Stabler" <eexgs@...>
wrote:

>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "ballendo" <ballendo@> wrote:
>
> > and machine short flats where you'd like to give support or place
> >tapped holes or through holes for mounting.) There's really no need
> >to make the entire bar into a "flat" with 90°
>
> I came to the same conclusion myself with a mouthfull of sandwich this
> lunch time, considering the low loading I could almost attach the
> things with "bluetac" (used for holding up posters etc) :)
>

If it is so low loading, then silver steel will be much simpler than
messing around with angles and bearings and cutting hex or square
stock into something useable.

But, there is always that gee-wizz factor of unconventional stuff.

Dave